53
3.2 HOW TO CHANGE CONTROL PANEL SETTINGS
The maximum programable time for each
exercise is set next:
MAX TIME = 20
Key in the time in minutes. To save the
selection, press ENTER.
Then enable the (+) and (–) keys to modify
the value of the reference heart rate for CHR
type workouts:
+/- KEYS / CHR = ON
To select the setting, press the
corresponding number key:
1 to disable the “+” and “–” keys
(OFF appears)
2 to enable the “+” and “–” keys
(ON appears)
then, to save the selection, press ENTER.
The function keys are then disabled so that
the equipment can only be used with the
Smartkey*:
FUNCTION KEYS = ON
To choose the setting, press the
corresponding number key:
1 to disable the function keys
(OFF appears)
2 to enable the function keys
(ON appears)
then, to save the settings, press ENTER.
Next, activate the option of increasing the
duration of Manual and CHR workouts with
the ENTER key:
ENTER TO INCREASE TIME = ON
To choose the setting, press the
corresponding number key:
1 to disable the ENTER key
(OFF appears)
2 to enable the ENTER key
(ON appears)
Then, to save the setting, press the ENTER
key.
At this point return to Standby.
If the CLEAR key is pressed at any time, the
procedure is interrupted and the equipment
returns to Standby mode.
2_Top_En.P65 30/05/2002, 13.5653
To Next Page
Loading...
