65
3.11 OTHER MESSAGES APPEARING ON THE DISPLAY
3.11 Other messages appearing on the display
During the workout, the display may show
the following messages:
❒ Increase workout time
During Manual or CHR workouts, you can
increase the set time at the end of the workout
by pressing the ENTER key (if the key has
been enabled accordingly during
configuration: see section 3.2). During the
last minute, the display will show:
ENTER TO INCREASE TIME
each time you press the ENTER key, the
duration of the workout increases by 1
minute. During the last minute of exercise,
the lower set of three values on the digital
display is shown, and includes the time
remaining.
❒ Check presence of heart rate signal
If no heart rate signal is detected at the start
of a CHR or Test workout, this message
appears on the display:
WEAR CHEST BAND
If your heart rate still hasn’t been detected
after 1 minute, the workout is cancelled.
The same message appears if the heart rate
signal disappears during any workout started
with the chest band.
❒ Cool down
At the end of each exercise, the equipment
suggests a cool down time. The display
shows:
COOL DOWN
❒ Check maximum heart rate value
If your heart rate exceeds 85% of the
maximum theoretical level, the equipment
emits a beep and this message appears on
the display:
HIGH HEART RATE
❒ Recommended speed
During the workout, the display shows the
recommended exercise speed at regular
intervals:
MAINTAIN 50-60 RPM
where the RPM (rounds per minute) are
indicated in the lower set of three figures on
the display as “speed.”
2_Top_En.P65 30/05/2002, 13.5665
To Next Page
Loading...
