1730–Series Operating Instructions
2–9
6 AUXILIARY CONTROL OUT
A 9–pin, D–type, female connector to interface with the 1720–Series. Auxiliary
control consists of a signal line and an interface bus. The bus provides the
1730–Series with control of the 1720–Series Vectorscope.
7 AC FUSE
Holder for the instrument’s mains fuse.
8 AC POWER
A standard ac plug receptacle for 120 or 240 Vac power mains. Plug is
compatible with any of the three power cord options available for the 1730–Se-
ries Waveform Monitor.
9 DC INPUT
A knockout for installation of a 1700F10 Field Upgrade Kit dc power plug.
Operator’s Checkout Procedure
The following procedure is provided as an aid in obtaining a display on the
1730–Series Waveform Monitor (operator familiarization), and as a quick check
of basic instrument operation. Only instrument functions, not measurement
quantities or specifications, are checked in this procedure. Therefore, a
minimum amount of test equipment is required. All checks are made with the
cabinet on and all internal jumpers in the factory–set position.
If performing the Operator’s Checkout Procedure reveals improper operation or
instrument malfunction, first check the operation of associated equipment. If
associated equipment is performing normally, refer the 1730–Series Waveform
Monitor to qualified service personnel for repair or adjustment.
When a complete check of the instrument performance to its specification is
desired, refer to the Performance Check (which should only be performed by
qualified service personnel) in Section 5 of this manual.
This procedure requires a source of composite video. The TEKTRONIX
1410–Series Television Test Signal Generator (1410 for NTSC, 1411 for PAL, or
1412 for PAL–M) with Sync, Color Bar, and Linearity modules was used in
preparing this procedure.
Power Input
To Next Page
Loading...
Need help?
General
