1730–Series Installation
3–10
Do not attempt to carry a cabinetized instrument without installing the mounting
screws. Without the mounting screws there is nothing to hold the instrument in
the cabinet if it is tipped forward.
The instrument is secured to the cabinet by two 6-32 Pozidriver screws, located
in the upper corners of the rear panel. See Figure 3-7.
Cabinet Securing Screws
Figure 3-7: Rear view of the instrument, shown in the cabinet, with the
securing screws identified.
The optional 1700F05 side-by-side rack adapter, shown in Figure 3-8, consists of
two attached cabinets. It can be used to mount the 1730-Series and another
half-rack width instrument in a standard 19-inch rack.
Cabinetizing
Rack Adapter
To Next Page
Loading...
Need help?
General
