Tektronix 2212 - Page 221

Equipment Required (See Table C-1)
Calibration Generator (Item 1)
Leveled Sine-Wave Generator (Item 2)
Low-Frequency Sine-Wave Generator (Item 4)
TV Signal Generator (Item 6)
Dual-Input Coupler (Item 8)
50 Q Coaxial Cable (Item 7)
50 Q ENC Termination (Item 11)
600 Q ENC Termination (Item 12)
Initial Control Settings
Vertical
POSITION ..................................... Midrange
MODE ............................................ CH 1
CH 1 VOL TS/DIV .......................... 0.1 V
CH 2 VOL TS/DIV .......................... 1 V
V ARiable ....................................... Off
AC-GND-DC (CH 1 and CH 2) ...... DC
Horizontal
POSITION ..................................... Midrange
MODE ALT MAGN ....................... Off
SEC/DIV ......................................... 0.2 µs
V ARiable ....................................... Off
Xl, X10, X50 Magnifier ................ Xl
Trigger
HOLDOFF ...................................... MIN
LEVEL ............................................ Midrange
SLOPE ............................................ Positive Going
MODE ............................................ P-P AUTO
Performance Tests
SOURCE ........................................ VERTical MODE
COUPLING .................................... DC
2212 User Manual
C-19