I_
c?
Appendix
B:
Specification
E
i?
Table A-4: Electrical Characteristics (Cont.)
c
Characteristics Performance Requirements
LT
Delay Time Differential Measurement Accura-
cy (Runs After Delay only)
+15" C to
+35"
C
21% of reading, 20.5% of full scale
(10 divisions).
+2% of reading, 20.5% of full scale (1 0 divisions).'
Exclude delayed operation when the A and
B
SECIDIV
knobs
are locked together at any sweep speed or when the
A
SECI
DIV
switch is faster than 0.5 ps per division. Accuracy applies
over the
B
DELAY TIME POSITION control range.
Digital Storage Display
Vertical
Resolution
10 bits (1 part in
1024).'
Display waveforms are calibrated for 100 data points per divi-
sion.
Position Registration
NON-STORE
to
STORE
20.5 division at graticule center at
VOLTSIDIV
switch settings
from 2
mV per division to 5 V per division.
-
-
CONTINUE
to
SAVE
20.5 division at
VOLTS/DIV
switch settings from 2 mV per
division to
5
V per division.
SAVE
Mode Expansion or Compression
Up to 10 times as determined by the remaining
VOLTSIDIV
Range
switch positions up or down.
2
mV per division acquisitions cannot be expanded, and 5 V
per division acquisitions cannot be compressed.
Any portion of a stored waveform vertically magnified or com-
pressed up to 10 times can be positioned to the top and to
the bottom of the graticule area.
Storage Display Expansion Algorithm Error
50.1
%
of full scale.'
Storage Display Compression Algorithm
+0.16% of reading +0.4% of full scale.'
Error
Horizontal
Resolution
10 bits (1 part in
1024).'
Calibrated for 100 data points per division.
Differential Accuracy
Graticule indication of time cursor difference is
22% of the
readout value, measured over the center eight divisions.
SAVE
Mode Expansion Range
(YT
mode)
10 times as determined by the
XI
0 MAG switch.
Expansion Accuracy
Same as the Vertical.'
-
-
-
-
--
1
Performance requirement not checked in manual.
iz
CI
2232
User
Manual
A-1
7
To Next Page
Loading...
Need help?
General
