Appendix
6:
Specification
Table A-4: Electrical Characteristics (Cont.)
Characteristics
Performance Requirements
-
-
Digital Readout Display
CURSOR
Accuracy
Voltage Difference
k3%
of the AV readout value,
k0.4%
of full scale
(8
divisions).
Applies within center
6
divisions.
Time Difference
RECORD or ROLUSCAN
SAMPLE or AVERAGE
2
1
display intervaL7
PEAKDET or ACCPEAK
22
display interval.ll7
REPETITIVE
SAMPLE or AVERAGE
k(2
display interval
+
0.5
ns).ll7
ACCPEAK
k
(4
display interval
+
0.5
n~).'$~
X-Y
Operation
(XI
Magnification Only)
Deflection Factors
Same as vertical deflection system with the
VOLTS/DIV
Vari-
able controls in the
CAL
detent position.
NON-STORE
~ccuracy~
X-Axis
+15O
C to
+35"
C
&3%
0"
C to
+50°
C
24%'
Y-Axis
Same as vertical deflection system.'
NON-STORE
Bandwidth
(-3
d~)~
X-Ax i s
DC to at least
2.5
MHz.
Y-Axis
Same as vertical deflection system.'
NON-STORE
Phase Difference Between
23
degrees from DC to
150
kHz.'
X-Axis and Y-Axis Amplifiers
Vertical Input Coupling set to DC.
STORE
Accuracy
X-Axis and Y-Axis
Same as digital storage vertical deflection system.'
'Performance requirement not checked in manual.
'A
display intewal is the time between two adjacent display points on a waveform.
8Measured with a DC-coupled, five-division reference signal.
A-18
Appendices
To Next Page
Loading...
