Troubleshooting
TDS5000B Series Service Manual
6-- 61
Table 6--9: BIOS Error messages (Cont.)
Error message Explanation
Memory Size Increased Memory size has increased since the last boot. If no
memory was added, then memory may be bad.
Memory Size Changed Memory size has changed since the last boot. If no
memory was added or removed, then memory may
be bad.
No Boot Device Available System did not find a boot device.
Off Board Parity Error A parity error occurred on an off-board card. This
error is followed by an address.
On Board Parity Error A parity error occurred in onboard memory. This
error is followed by an address.
Parity Error A parity error occurred in onboard memory at an
unknown address.
NVRAM/CMOS/PASSWORD cleared by
Jumper
NVRAM, CMOS, and passwords have been cleared.
The system should be powered off and the jumper
removed.
<CTRL_N> Pressed CMOS is ignored and NVRAM is cleared. User must
enter Setup.
To Next Page
Loading...
Need help?
General
