Tektronix TDS5000B Series Service Manual

Commands
5-10
TDS5000B Series Service Manual
CALibrate:CALProbe:CH2?
might return
:CALIBRATE:CALPROBE:CH2 0
indicating that the probe calibration passed for Channel 2.
CALibrate:FACtory
This command starts the factory calibration. This command functions the same
as the CALibrate:FACtory:STARt command.
CALibrate:FACtory
CALIBRATE:FACTORY
starts the factory calibration
CALibrate:FACtory:ABOrt
This command stops the factory calibration, resets to the initialization state, and
exits without changing the calibration data.
CALibrate:FACtory:STARt
CALibrate:FACtory:ABOrt
CALIBRATE:FACTORY:ABORT
stops the factory calibration
CALibrate:FACtory:CONTInue
This command does the next step in the calibration procedure. The calibration
step number is increased on successful completion of this step. If the calibration
step fails, the step number is not increased. You can use CALibrate:FACto-
ry:CONTinue, to repeat a factory calibration step that failed.
Follow this command with CALibrate:FACtory:STEPstatus? to determine
execution status.
Examples
Syntax
Example
Related C ommands
Syntax
Example

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English