Tektronix TDS5000B Series Service Manual

Commands
TDS5000B Series Service Manual
5-29
DIAg:RESults?
This query-only command returns an abbreviated status about the results of the
last diagnostic (or test) execution. For a more explanatory status message, use
the DIAg:RESults:VERBose query. This command is equivalent to selecting
Instrument Diagnostics from the Utilities menu, and then reviewing the
Diagnostic Status.
This query can be issued while diagnostics are still in progress.
DIAg:RESults:VERBose?
DIAg:RESults?
DIAg:RESults?
This query might return
:DIAG:RESULTS “135”
indicating the specific failure code of the first test failure that occurred.
DIAG:RESults?
This query might return
:DIAG:RESULTS “Pass”
indicating the specific failure code of the first test failure that occurred.
DIAG:RESults?
This query might return
:DIAg:RESults “*****”
indicating the diagnostic test was not run.
DIAg:RESults:VERBose?
This query-only command returns a more explanatory message about the results
of the last diagnostic (or test) execution that the DIAg:RESults? query. This
command is equivalent to selecting Instrument Diagnostics from the Utilities
menu, and then reviewing the Diagnostic S tatus.
This query can be issued while diagnostics are still in progress.
Related C ommands
Syntax
Example 1
Example 2
Example 3

Tektronix TDS5000B Series Specifications

General

Brand	Tektronix
Model	TDS5000B Series
Category	Test Equipment
Language	English