To Next PageTo Next Page
Need help?Do you have a question about the TELEDYNE API T300M and is the answer not in the manual?
General| Brand | TELEDYNE API |
|---|---|
| Model | T300M |
| Category | Measuring Instruments |
| Language | English |
Explains various safety symbols like electrical shock, hot surfaces, and technician requirements.
Emphasizes proper usage and avoiding hazardous consequences like sampling combustible gases.
Details Teledyne API's warranty policy, coverage terms, and product return procedures.
Warns against actions like improper ESD handling that can void the warranty.
Explains special notices (Attention, Important, Note) and document structure.
Lists key technical specifications for the T300 and T300M models, including ranges and performance.
States EPA designation and lists safety, EMC, and other type certifications.
Guides on safely unpacking the instrument and checking for shipping damage.
Describes the front, rear, and internal chassis layout of the T300/T300M analyzer.
Covers electrical and pneumatic connections, and initial startup.
Orients users to the Home, Dashboard, Alerts, Calibration, Utilities, and Setup menus.
Details configuration options for Data Logging, Events, Dashboard, AutoCal, Vars, Outputs, Instrument, and Comm.
Explains RS-232 communication and the DCE/DTE switch.
Covers modes, baud rate, and serial communication setup for COM ports.
Details available communication protocols like MODBUS and Hessen.
Provides essential details, gas requirements, and data recording devices before calibration.
Details calibration and check procedures for basic and valve option configurations.
Describes the Auto Cal feature for unattended periodic calibrations.
Guides on evaluating calibration quality and calibrating electronic subsystems.
Provides calibration procedures for O2 and CO2 sensors.
Addresses calibration requirements for US EPA compliance.
Presents a typical schedule for routine maintenance and using functions to predict failures.
Guides on downloading reports and acquiring software/firmware updates.
Details periodic maintenance tasks like filter replacement, pump rebuild, and leak/flow checks.
Provides methods for identifying and resolving performance problems using alerts and dashboard functions.
Provides steps for repairing the critical flow orifice and filter.
Guides on safely removing and replacing the GFC Wheel assembly.
Details how to check and adjust the sync/demodulator circuit gain.
Provides steps for replacing the DOM, including data backup and recalibration.
Explains the principles behind the analyzer's measurement technique, including Beer's Law and GFC.
Covers the analyzer's pneumatic system, flow control, and sensors.
Provides a block diagram and explanation of the analyzer's electronic components.
Explains adaptive filtering, calibration processes, and measurement algorithms.
