54 Getting Started 083730300A DCN8101
2.3.4 STARTUP, FUNCTIONAL CHECKS, AND INITIAL CALIBRATION
Impact on Readings or Data
The analyzer’s cover must be installed to ensure that the
temperatures of the GFC Wheel and absorption cell
assemblies are properly controlled.
We recommend reading Section 6 to become familiar with the principles of operation.
When the instrument is first started (Section 2.3.4.1, check its functionality
(Section 2.3.4.3) and run an initial calibration (Section 4). Section 2.4 introduces the
menu system, and Section 2.5 provides setup/customization instructions.
2.3.4.1 STARTUP
Upon initial startup, a sequence of status screens (Figure 2-28) appear prior to the Home
page (Figure 2-29).
Figure 2-28. Status Screens at Startup
Upon any startup, this instrument should warm up for approximately one hour before
reliable measurements can be taken.