User Manual for Oscar GNSS Receiver v2.4
99
the external power supply with 12V output.
Detailed steps of button operation:
1. Set up Oscar according section 2.1 Setting up Oscar after all the
components above are ready, ensure one battery is installed in Oscar and
insert one SIM card when 4G/3G/2G network is required for operation;
2. Long press the power button to power on Oscar;
3. Press FN button to select [Mode Config], press the power button to enter
the work mode options;
4. Select [Base Mode] and press the power button;
5. If using Tersus Caster Service, select [TCS] and press the power button to
enter TCS network settings; Set the format, server and press the power
button to confirm.
6. If using internal radio, select [Internal Radio] and press the power button to
enter radio setting; Set protocol, format, power, channel, frequency and
press the power button to confirm.
7. If using external radio, select [External Radio] and press the power button
to configure; Set Baud rate as 115200, format and press the power button
to confirm.
8. Above all, setting Oscar as a base is completed.
Detailed steps of software operation:
1. Set up Oscar according section 2.1 Setting up Oscar after all the
components above are ready, ensure one battery and one SIM card are
installed in Oscar;
2. Long press power button to power on Oscar;
3. Use NFC function to launch Nuwa app. While the screen of TC20/TC50
Controller is unlocked, put TC20/TC50 Controller close to the Oscar NFC
To Next Page
Loading...
