TERSUS Oscar - Page 116

User Manual for Oscar GNSS Receiver v2.4
115
5. There is no correction data for rover when using Ntrip work mode.
Solutions:
(1) Check whether the IP address, port, user name, password is correct;
(2) Check network. Try to use PDA/controller network to compare. Make sure
there is no issue on the contact between the SIM card slot and the SIM
card.
(3) Obtain the SourceTable to check the receiver network module, ensure
there is no issue on CORS service.
(4) Try to log in with the same configuration and get a compared result if there
is an extra receiver.
(5) If still cannot log in, consult your CORS service provider.
6. How to export static observation data from Oscar?
Solutions:
(1) Connect Oscar receiver with a computer through a mini USB cable.
(2) The computer detects the Oscar receiver as an external disk.
(3) Open the Record folder, find the trs file and rinex file in its storage
according to recording date.
(4) Copy the static observation data and paste them to the designated folder in
your computer.
7. How to calibrate the E-Bubble of Oscar receiver?
Solutions:
(1) Firstly, install Oscar receiver on the tribrach of a tripod. Adjust the tribrach
to enable the bubble to the center.
(2) Next step, select <Adjust> in the Nuwa under Device Info -> E-Bubble to
complete the calibration.