EN
Machine does not feed at all
Lint or dust accumulated around feed
dog
Clean feed dog area
Feed dog lever are lowered
Check if feed dog lever is on right
position
Stitch length is too small Adjust stitch length
Machine does not feed
properly
Stitch length is with value 0 Adjust stitch length
Bobbin thread is about to end Rewind thread on the bobbin
Machine doesn’t work
Machines is not plugged Insert plug fully into outlet
Main switch is in position „0” Turn on the switch to „1”
Buttonhole lever is lowered Raise buttonhole lever
Buttonhole is raised during
buttonhole sewing
Lower buttonhole lever
Machine works too laud or
too slow
The thread tangled up in bobbin Reinsert bobbin and thread
Dirt in the bobbin and hook area
blocked feed dog
Clean feed dog
Machine has no oil Oil the machine
LED lamp doesn’t work
Main switch is in position „0” Turn on the switch to „1”
Lamp got burnt Replace LED lamp for new one
SAVE THESE INSTRUCTIONS
This product is for household use, or equivalent. This appliance complies with EMC Directive 2014/30/
EU covering the electromagnetic compatibility. Please note that on disposal, this product must be safely
recycled in accordance with relevant National legislation relating to electrical/ electronic products. If in
doubt please contact your retailer for guidance.
Texi Fox 25 87
To Next Page
Loading...
Need help?
General
