Textron MPE 850 OFF-ROAD - Installing Intake Manifold

59TD410023-B RLF
2
1
3
5
4
6
8
9
10
7
ENGINE REASSEMBLY
INSTALLING INTAKE MANIFOLD
The o-rings and seals are dependent on the intake
socket groove
1
and not interchangeable.
Observe the sealing contour when choosing
o-rings or seals.
– Closed groove: O-ring
2
– Groove with inspection port: Seal
3
1. Replace the o-rings or seals
5
.
2. Insert the o-rings or seals into the grooves
4
and lightly coat with petroleum jelly.
3. Check if two sleeves
7
are installed.
4. Hold the intake manifold
6
in position.
5.
6 mm: Screw in two bolts
8
lightly. Do not
tighten.
6.
5 mm: Install four bolts
9
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
7.
6 mm: Install two bolts
10
according to the
specification Other bolts M8 Standard. (See
section D Tightening torques und assembly
instructions.)
B