Textron MPE 850 OFF-ROAD - Installing Brackets and Oil Pressure Switch

75TD410023-B RLF
5
2
3
1
7
6
4
5
9
8
ADDITIONAL WORKING INSTRUCTIONS
4. 5 mm: Install four bolts
5
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
1. Hold the bracket
1
in position.
2.
5 mm: Install the bolt
2
according to the
specification Other bolts M6 high strength
thread locker. (See section D Tightening
torques und assembly instructions.)
3.
24 mm: Install the oil pressure switch
3
according to the specification Oil pressure
switch. (See section D Tightening torques und
assembly instructions.)
INSTALLING BRACKETS AND OIL PRESSURE SWITCH
Depending on the engine model, install the
brackets
4
and
5
or bracket
8
.
4. Hold the bracket
5
in position.
5.
5 mm: Install the bolt
6
according to the
specification Other bolts M6 high strength
thread locker. (See section D Tightening
torques und assembly instructions.)
6. Hold the bracket
4
in position.
7.
5 mm: Install two bolts
7
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
8. Hold the bracket
8
in position.
9.
5 mm: Install two bolts
9
according to the
specification Other bolts M6 Standard. (See
section D Tightening torques und assembly
instructions.)
C