Textron MPE 850 OFF-ROAD - Installing Cylinder Head

44 TD410023-B RLF
22
21
1
3
4
5
6
2
ENGINE REASSEMBLY
27. Assemble the oil pressure valve in the
sequence as illustrated
22
.
28. Coat the oil pressure valve
21
lightly with
engine oil.
29. Insert the oil pressure valve.
The crankcase is tightened in two stages. The
crankcase will be tightend only after the cylinder
head installation.
30. Screw the housing together according to the
specification Crankcase bolts First stage.
(See section D Tightening torques und
assembly instructions.)
31. Turn the engine 180°.
INSTALLING CYLINDER HEAD
1. Insert two centering pins
3
.
2. Replace the cylinder head gasket.
3. Apply the cylinder head gasket.
Observe the installation position:
– Exhaust side
4
– Inscription
5
4. Place the cylinder head on the crankcase.
Observe the installation position:
– Exhaust side
2
– Starter
6
5. Insert eight sleeves
1
.
B