Operation
Instrument Controls Menu
3-64 Model 48i Instruction Manual Thermo Electron Corporation
Choose Signal Type To Output The Choose Signal Type To Output screen displays a submenu list of the
analog output signal group choices. Group choices are Concentrations,
Other Measurements, and Analog Inputs (if the I/O expansion board is
installed). This allows the user to select the output signal to the selected
output channel. The Concentrations screen is shown below. See Table 3-7
below for a list of items for each signal group choice.
• In the Main Menu, choose Instrument Controls > I/O Configuration >
Analog Output Config > Select Channel > Choose Signal To Output.
• Use and to move the cursor up and down.
• Press to select a choice.
• Press to return to the Analog Output Config menu or to
return to the Run screen.
Bench Temp User-set alarm min value User-set alarm max value
Pressure User-set alarm min value User-set alarm max value
Sample Flow User-set alarm min value User-set alarm max value
Intensity User-set alarm min value User-set alarm max value
Motor Speed User-set alarm min value User-set alarm max value
Everything Else 0 units 10 units
Table 3-6. Analog Output Zero to Full-Scale Table
Output Zero % Value Full-Scale 100% Value
XXLO WCONCENTRATIONXXLO W
CO 15.80 PPM
SAMPLE 12:34 ALARMx
CHOOSE SIGNAL TYPE:
CONCENTRATIONS
OTHER MEASUREMENTS
ANALOG INPUT
RANGE AVG DIAGS ALARM
To Next Page
Loading...
