3. AUTOMATIC TRACKING MODE
3-2
1) Auto tracking mode should be used only after powering up and instrument fully acclimated to the
atmospheric surroundings.
2) Auto tracking status sometimes can be unstable for a few seconds after the optical path is
disturbed by a passing car or person.
3) There are fine and coarse modes in distance measuring mode. The coarse mode is used for
moving or unstable objects. The fine mode is for objects which are fixed and/or for precise
measurements.
Please refer to chapter 5.4 "Fine Mode and Coarse Mode".
4) While the instrument is in the Waiting status retracking function will resume when target is within
scanning area.
5) For setting the parameters for auto tracking mode, refer to chapter 15 "Special mode (Menu key
operation)" The following are the parameters available to set.
1) Setting Search Range 2) Setting Search Pattern 3) Setting Waiting Time
4) Setting Scan Width 5) Setting Tracking Speed 6) Setting Detecting Sensitivity
To Next Page
Loading...
