Topcon AP-L1A - AREA Set:setting Area Range; Remote; REMOTE: Remote Mode (Wireless Communication Mode)

15. SPECIAL MODE (MENU KEY OPERATION)
15-9
15.2.2 AREA SET: Setting Area Range
(See Chapter 7.2 "Area Setting" )
1) INPUT NEZ : Input coordinate value for setting area.
2) MOVED SET : Setting area by collimating.
3) SETTING AREA : Select ON / OFF function for setting area.
User may set from one to four set areas.
15.3 REMOTE
15.3.1 REMOTE : Remote Mode (Wireless communication mode)
The remote mode is to communicate between AP-L1A and wireless terminal WT-1A/1B. It
enables AP-L1A to be controlled for data collection or stakeout by data terminal FS/2. This is
only possible when remote mode is activated.
 Selecting [F1:REMOTE] , Mode changes to remote mode. See Chapter 7.8 "Remote
Mode".