Topcon AP-L1A - 15 Special Mode (Menu Key Operation)

15. SPECIAL MODE (MENU KEY OPERATION)
15-1
15. SPECIAL MODE (MENU KEY OPERATION)
Special mode is used for each presetting or measuring as menu shows below.
The settings here will be memorized after power OFF.
1st layer MENU 2nd layer MENU 3rd layer MENU 4th layer MENU
F1: PARAMETERS F1: TRK F1: SEARCH F1: PATTERN
F2: AREA
F2: WAIT TIME

F3: SCAN WIDTH

F1: ADJ AXIS(M)

F2: ADJ AXIS(A)

F3: TRK SPEED

F1: TRK SENSITIV

F2: MEAS F1: TILT ON/OFF

F2: DATE & TIME

F3: OCC. POINT

F1: RST A/M

F3: COM F1: COM1 F1: BIT FORMAT
F2: TRANS SPEED
F3: TERMINATE
F2: COM2 F1: BIT FORMAT
(REMOTE) F2: TRANS SPEED
Only for AP-L1AN F3: PROTOCOL
F1: TERMINATE
F2: PROGRAMS F1: TEACH F1: SET POINT F1: WRITE
F2: DELETE
F2: PARAMETERS F1: SEARCH
F2: EDM MODE
F3: CYCLE TIME
F3: GO

F2: AREA SET F1: INPUT NEZ

F2: MOVED SET

F3: SETTING AREA

F3: REMOTE F1: REMOTE
 