15. SPECIAL MODE (MENU KEY OPERATION)
15-6
2) COM 2: Setting Bit format , Transmission Speed (Baud rate) and so forth of COM-2
Set AP-L1AN and external device to match each other when performing
communication.
AP-L1A (with wireless modem) does not have this setting item.
2-1) BIT FORMAT: This is Communication Format for COM-2.
Select the communication format, such as data length, stop- bit/parity of COM-2.
Selecting items Set items
D8 S1 NONE 8bit, stop 1, NONE
D8 S2 NONE 8bit, stop 2, NONE
D7 S1 NONE 7bit, stop 1, NONE
D7 S2 NONE 7bit, stop 2, NONE
D8 S1 EVEN 8bit, stop 1, EVEN
D8 S2 EVEN 8bit, stop 2, EVEN
D7 S1 EVEN 7bit, stop 1, EVEN
D7 S2 EVEN 7bit, stop 2, EVEN
D8 S1 ODD 8bit, stop 1, ODD
D8 S2 ODD 8bit, stop 2, ODD
D7 S1 ODD 7bit, stop 1, ODD
D7 S2 ODD 7bit, stop 2, ODD
2-2) TRANS SPEED: Communication Speed for COM-2
Select the baud rate of COM-2.
Selecting items Set items
9600 9,600 baud rate
4800 4,800 baud rate
2400 2,400 baud rate
1200 1,200 baud rate
Setting value at shipping time from factory is 2,400 Baud.
2-3) PROTOCOL: Setting Protocol of COM-2
Selecting items Set items
SERIAL Based on RS-232C. (3 lines system)
MODEM Based on RS-232C.
2-4) TERMINATE: Terminal Code of COM-2
Selecting CR (carriage return), or LF (line feed ) will be added at the end of data.
Selecting items Set items
ETX ETX
ETX+CR ETX+CR
ETX+CRLF ETX+CRLF
Setting mode at shipping time from factory is ETX+CRLF.
To Next Page
Loading...
