Powering the Receiver
4-2
P/N: 1023998-01
Managing Power
Operating Hours
Table 4-1 describes the use conditions and the operating hours of the receiver. The first values in the
Approximate Hours of Operation column are obtained while using both batteries (internal and
removable external). The second values are obtained while using the external removable battery only
(internal battery is discharged).
Table 4-1. HiPer VR Approximate Hours of Operation
Use Condition Description
Approximate Hours of
Operation
a
Static Survey Static setup logging raw GNSS
data at 1-Hz.
15 hours
LongLink RTK Base Base transmitting RTCM3
differential corrections to one or
multiple rovers.
15 hours
LongLink RTK
Rover
Rover receiving RTCM3 differential
corrections over LongLink
connected through Bluetooth to a
data collector.
15 hours
Network RTK Rover Rover receiving RTCM3 differential
corrections from a Network
correction service, and connected
through Bluetooth to a data
collector.
13 hours
UHF Receive Only
Mode
Rover receiving RTCM3 differential
corrections over UHF radio
connected through Bluetooth to a
data collector.
10 hours
UHF Transmitting
at 0.5 W
Base transmitting RTCM3
differential corrections at 0.5
Watts
8 hours
UHF Transmitting
at 1 W
Base transmitting RTCM3
differential corrections at 1-Watt
6 hours
UHF Repeater at
1-Watt
Receiving RTCM3 corrections, and
transmitting RTCM3 differential
corrections at 1-Watt.
6 hours
FH915 Receive
Only Mode
Rover receiving RTCM3 differential
corrections over FH915 radio
connected through Bluetooth to a
data collector.
11 hours
FH915 Transmitting
at 0.25 Watt
Base transmitting RTCM3
differential corrections at 0.25
Watt
8 hours
FH915 Transmitting
at
1-Watt
Base transmitting RTCM3
differential corrections at 1-Watt
6 hours
To Next Page
Loading...
Need help?
General
