Toro Field Pro 6040 - Page 179

AdjustingtheNeutralSwitches
g416383
Figure71
(leftsideassemblyshown)
1.Neutralswitch
3.Jamnut(2each)
2.LED
1.ParkthemachineonalevelsurfaceandsetthekeyswitchtotheOFF
position.
2.Lowertheoperator’scushion.
IMPORTANT
Becarefulnottoscratchthefaceofthesensorwhenmeasuringor
adjustingthesensorclearance.
3.WhenthetractioncontrolleverisintheNEUTRALposition,theclearance
betweenthesensingplateandtheendoftheaerationswitchis6.4to7.8
mm(0.25to.31inch).Checktheclearancefortherightsideandleftside
neutralswitch.
4.Toadjusttheswitch:
A.Ensurethattheaerationbailmovesfreelyandreturnsfully.
B.Loosenthejamnutsthatsecuretheswitchtothebracketandpositionthe
switchtoallowcorrectclearancebetweenswitchandthesensingplate.
C.Tightentheswitchjamnutsfrom24N·m(212in-lb).
D.Recheckswitchtotractioncontrolleverclearance.
5.Testtheoperationoftheneutralswitchesbeforereturningthemachineto
service.
FieldPro®6040
Page6–15
ElectricalSystem:TestingtheElectricalComponents
22267SLRevA