Toro Multi Pro 1750 - Wiring Table - Rate Valve

Figure39
1.4-pinadapter(ratevalve)4.Bluewire(DINwire
harness)
2.Graywire(4-pinadapter)5.Brownwire(DINwire
harness)
3.Greenwire(4-pinadapter)6.DINharness(ratevalve)
WiringTable—RateValve
Wirecolorcodes—DINwire
harness
Wirecolorcodes—4-pin
adapter(rate-valveposition)
NotapplicablePink
NotapplicableBlack
Brown
Gray
Blue
Green
4.InsertthebrownwireoftheDINwireharnessinto
thebutt-spliceconnectoronthegraywireofthe4-pin
adapterfortheratevalve.
5.Centerthecrimpingtooloverthebutt-spliceconnector
andwiresandcrimptheconnectorsecurely.
6.InsertthebluewireoftheDINharnessandbutt-splice
connectoronthegreenwireofthe4-pinadapterfor
theratevalve(Figure39).
7.Centerthecrimpingtooloverthebutt-spliceconnector
andwiresandcrimptheconnectorsecurely.
8.Useaheatguntoshrinktheinsulatingsleevesofthe
butt-spliceconnectorsofthewiresthatyouinstalled
insteps3through6.
9.TerminatethegreenandyellowwireoftheDIN
connectorasfollows:
A.Cuttheconductorsofthegreenandyellowwire
ushwiththeinsulation(Figure40).
Figure40
1.Greenandyellowwire
(cuttingtheconductor)
3.Tapingwirestogether
2.Tapingtheendofthe
greenandyellowwire
B.Wraptheendofthegreenandyellowwirewith
electricaltapetosealthewire(Figure40).
C.Foldthegreenandyellowwiretothebrownwire
andbluewireandwrapthe3wirestogetherwith
theelectricaltape(Figure40).
20