Toro Multi Pro 1750 - Cleaning the Agitation and Section Valves; Removing the Valve Actuator

Note:ReplaceanydamagedorwornO-ringsforthe
plug,bowl,orboth.
7.Installthenewpressure-lterelementintothelter
head(Figure110).
Note:Ensurethatthelterelementisrmlyseated
intothelterhead.
8.Installthebowlontothelterheadandtightenby
hand(Figure110).
9.Installthecapontothebowlandtightenbyhand
(Figure110).
CleaningtheAgitationand
SectionValves
•Tocleantheagitationvalve,refertothefollowing
sections:
1.RemovingtheValveActuator(page53)
2.RemovingtheAgitation-ManifoldValve(page54)
3.CleaningtheManifoldValve(page55)
4.AssemblingtheManifoldValve(page57)
5.InstallingtheAgitation-ManifoldValve(page57)
6.InstallingtheValveActuator(page58)
•Tocleanthe3sectionvalves,refertothefollowing
sections:
1.RemovingtheValveActuator(page53)
2.RemovingtheSectionValveManifold(page54)
3.CleaningtheManifoldValve(page55)
4.AssemblingtheManifoldValve(page57)
5.InstallingtheSection-ManifoldValve(page58)
6.InstallingtheValveActuator(page58)
RemovingtheValveActuator
1.Positionthesprayeronalevelsurface,settheparking
brake,stopthepump,shutofftheengine,andremove
thekey.
2.Removethe3-pinconnectorofthevalveactuatorfrom
the3socketelectricalconnectorofthesprayerharness.
3.Removetheretainerthatsecurestheactuatortothe
manifoldvalvefortheratecontrol,agitation,master
boom,orboom-sectionvalve(Figure111).
Note:Squeezethe2legsoftheretainertogetherwhile
pushingitdown.
Note:Retaintheactuatorandretainerforinstallation
inInstallingtheValveActuator(page58).
Figure111
Section-ValveActuatorShown(theagitation-valveactuator
issimilar)
1.Valveactuator(section
valveshown)
3.Stemport
2.Retainer
4.Removetheactuatorfromthemanifoldvalve.
53