Toro Multi Pro 1750 - Assemble Eductor-Shutoff Valve for Machines W. Optional Eductor Kit; Assemble the Throttle Valve for Machines W;O Optional Eductor Kit

Figure58
1.Screw(6-32x5/8inch)5.Nut—stainlesssteel(6
mm—throttle-valvemount)
2.Handle6.Washer-headscrew
(#6—throttle-valvemount)
3.Agitationthrottlevalve7.Agitation-valvebracket
4.Throttle-valvemount
(nylon)
8.Bolt(6x12mm)
2.Ifnotassembled,insertthe4stainlesssteelnutsinto
theslotsinthenylonthrottle-valvemountforthe
agitationthrottlevalve(Figure58).
3.Assembletheagitationthrottlevalveintothe
throttle-valvemountasshownin(Figure58)
4.Securethethrottle-valvemounttotheagitationthrottle
valvewiththescrew(6-32x5/8inch)asshownin
(Figure58).
5.Assemblethethrottlevalveandmounttothe
agitation-valvebracket(Figure58)withthe4bolt(6x
12mm).
AssemblingtheEductor–ShutoffValve
forMachineswiththeOptionalEductor
Kit
1.Alignthehoseintheeductor-shutoffbracketwiththe
studsoftheeductor-shutoffvalveasshowninFigure
59.
Figure59
1.Flangelocknut(1/4inch)3.Stud(eductor-shutoff
valve)
2.Eductor-shutoffbracket
2.Assemblethebrackettothevalve(Figure59)withthe
4angelocknuts(1/4inch)
3.Torquetheangelocknutsto1017to1243N∙cm(90
to110in-lb).
AssemblingtheThrottleValvefor
MachineswithouttheOptionalEductor
Kit
Note:Ifyourmachinehastheoptionaleductorkit,skipto
AssemblingtheThrottleValveandEductor-ShutoffValvefor
MachineswiththeOptionalEductorKit(page30).
1.Aligntheslotsintheagitation-valvebracketwith
theholesinthemountforthethrottle-valvebracket
(Figure60).
Figure60
1.Mount(throttle-valve
bracket)
3.Flange-headbolt(5/16x
3/4inch)
2.Agitation-valvebracket
4.Frontofthemachine
29