Multi Pro 1750Page 1 − 4Safety
Jacking Instructions
CAUTION
When changing attachments, tires or perform-
ing other service, use appropriate jacks and
supports. Make sure machine is parked on a sol-
id, level surface such as a concrete floor. Prior
to raising machine, remove any attachments
that may interfere with the safe and proper rais-
ing of the machine. Always chock or block
wheels. Use appropriate jack stands to support
the raised machine. If the machine is not proper-
ly supported by jack stands, the machine may
move or fall, which may result in personal inju-
ry.
IMPORTANT: Before raising the sprayer, it is rec-
ommended to empty the spray tank. If the spray
tank is not emptied, consider the extra weight of
spray tank contents when choosing appropriate
jacks, hoists and jack stands for raising and sup-
porting the machine.
Jacking the Front End
1. Set parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely under the frame crossbar (Fig.
1).
3. Jack front of machine off the ground.
4. Position suitable jack stands under the frame to sup-
port the machine.
Jacking the Rear End
1. Set parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely on the rear frame support, be-
hind the rear tie downs (Fig. 2).
3. Jack rear of machine off the ground.
4. Position jack stands under the frame to support the
machine.
Figure 1
1. Front crossbar
1
Figure 2
1. Rear jacking points
1
1
Safety and Instruction Decals
Numerous safety and instruction decals are affixed to
the Multi Pro 1750. If any decal becomes illegible or
damaged, install a new decal. Decal part numbers are
listed in your Parts Catalog. Order replacement decals
from your Authorized Toro Distributor.
To Next Page
Loading...
Need help?
General
