Multi Pro 1750Page 3 − 8Kohler Gasoline Engine
Adjust Choke Cable
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Release the latch on the back of the seat and lift the
seat forward to access the engine.
3. Remove air cleaner cover and air filter from engine.
4. Move choke control on control panel while watching
choke plate in carburetor.
A. Choke plate should be fully open when choke
control is pushed in.
B. Choke plate should be fully closed when choke
control is pulled out.
5. If choke cable adjustment is needed, loosen cap
screw and nut that secure choke cable clamp. Reposi-
tion cable to allow correct choke operation. Secure
choke cable clamp.
6. Verify choke operation and assemble air cleaner.
1. Choke cable 2. Cable clamp
Figure 3
1
2
To Next Page
Loading...
