Multi Pro 1750Chassis Page 8 − 18
Parking Brake Cables
1. Hand grip
2. Parking brake lever
3. Clevis pin
4. Flat washer
5. Hair pin
6. Equalizer
7. Bellcrank
8. Retaining rings (2)
9. Parking Brake bracket
(shown split)
10. Parking brake cable − right
11. Parking brake cable − left
12. Clevis pin (2)
13. Return spring (2)
14. Parking brake switch
Figure 11
11
12
12
13
13
14
1
2
3
4
5
6
7
8
9
9
10
FRONT
RIGHT
Removing (Fig. 11)
1. Set the parking brake lever to the disengaged (down)
position.
2. Remove the hand grip from the parking brake lever.
Loosen set screw on parking brake lever knob and turn
knob fully counterclockwise to loosen cable adjustment.
3. Remove the front left fender assembly to allow ac-
cess to cable connection at parking brake lever.
4. Remove hair pin, flat washer and clevis pin (item 3)
that secures the brake equalizer to the bellcrank.
5. Remove retaining rings that secure brake cables to
parking brake bracket.
6. Remove cable ends from equalizer plate and re-
move cables from parking brake bracket.
7. Remove both rear wheels (see Wheel Assemblies in
this chapter).
8. Loosen brake cable jam nuts that secure parking
brake cable to caliper bracket.
9. Remove return spring end from clevis pin on parking
brake lever.
10.Disconnect parking brake cable from caliper bracket
and caliper lever.
11.Record routing of cables and location of cable ties
and r−clamps before removing cables from machine.
Installing (Fig. 11)
1. Route cables through machine and secure with
cable ties and r−clamps as recorded. Make sure that the
brake cables do not contact moving components during
machine operation.
2. Slide parking brake caliper onto caliper bracket.
3. Connect parking brake cable to parking brake lever
with clevis pin.
To Next Page
Loading...
