Multi Pro 1750Chassis Page 8 − 10
Service and Repairs
Wheel Assemblies
1. Front wheel assembly (2) 2. Rear wheel assembly (2) 3. Lug nut (5 per wheel)
Figure 5
FRONT
RIGHT
75 to 80 ft−lb
(102 to 108 N−m)
1
2
3
3
Wheel Removal (Fig. 5)
1. Park machine on a level surface, stop spray pump,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Chock front and rear of wheels that are not to be re-
moved.
3. Jack wheel that is to be removed off the ground (see
Jacking Instructions in Chapter 1 − Safety in this manu-
al). Support raised machine with jack stands.
4. Remove lug nuts and wheel assembly.
Wheel Installation (Fig. 5)
1. Install wheel assembly with valve stem facing out
and secure to hub with lug nuts.
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury. Torque wheel lug nuts
from 75 to 80 ft−lb (102 to 108 N−m).
2. Torque lug nuts evenly in a crossing pattern from 75
to 80 ft−lb (102 to108 N−m).
3. Lower machine to ground.
To Next Page
Loading...
