Toro Multi Pro 1750 - Page 198

Multi Pro 1750Page 6 − 24Spray System
Spray Control Manifold Assembly (Serial Number Above 315000000)
1. Mounting plate
2. Flange nut (2)
3. Flange nut (6)
4. Hose (from spray pump)
5. Hose clamp (5)
6. Elbow fitting
7. Clamp (11)
8. Gasket (11)
9. Fork (6)
10. Pressure filter assembly
11. Hex head screw (2)
12. Straight fitting (2)
13. Hose (to tank)
14. Valve actuator − regulating
15. Valve actuator − On/Off
16. Adapter
17. Agitation throttle valve
18. Hose (to agitation nozzles)
19. Threaded adapter
20. Elbow fitting
21. Hose (to flowmeter)
22. O−ring (6)
23. Cap (3)
24. Cap (2)
25. Rate valve
26. Agitation valve
27. Agitation bypass valve
28. Master boom valve
29. Master boom bypass valve
30. Flange head screw (6)
31. Actuator fork (3)
32. Hose adapter
33. Hose (to pump)
34. Flange head screw (3)
Figure 12
FRONT
RIGHT
1
2
3
4
5
5
5
5
5
6
7
7
7
7
7
7
8
8
8
8
8
8
8
9
9
9
10
11
12
12
13
14
15
16
17
18
19
20
21
26
27
29
28
30
22
23
34
23
23
24
24
25
31
32
33
15
Thread
Sealant
The spray control manifold assembly includes a spray
product filter, the rate control valve, the agitation valve
with bypass valve, the master boom valve with bypass
valve, and the agitation throttle valve.
IMPORTANT: Each valve actuator has an internal
circuit breaker to protect the actuator motor. The
circuit breaker should reset in 20 seconds after
power to the actuator is removed.