Multi Pro 1750Page 7 − 38Drive Train
6. Assemble R−1 and 2−3 fork shaft:
A. Insert R−1 fork shaft into R−1 fork.
B. Drive lock pin into fork and fork shaft. Pay atten-
tion to direction of slit in lock pin.
C. Insert 2−3 fork shaft into 2−3 fork.
D. Drive lock pin into fork and fork shaft. Pay atten-
tion to direction of slit in lock pin.
1. Lock pin
2. Shift fork
3. Fork shaft
Figure 61
7. Assemble countershaft:
A. Use a press to install two (2) new bearings onto
countershaft.
B. Install collar and retaining ring.
C. Install countershaft gear onto shaft.
D. Install retaining ring.
E. Slide collar onto shaft.
F. Use a press to install new bearing.
8
7
5
6
4
3
2
1
1. Bearing
2. Collar
3. Gear
4. Collar
5. Retaining ring
6. Retaining ring
7. Bearing (2)
8. Countershaft
Figure 62
To Next Page
Loading...
