Toro Reelmaster 5010- H - Fault 57: Mismatched Cutting Unit Sizes

Fault57:MismatchedCuttingUnitSizes
InfoCenterDisplay:
_____ FAULT#57 _____
CUSizeIncompatible
FaultDescription
Thecuttingunitsizes(5-inchand7-inchdiameterreelunits)aremixed.
CircuitDescription
TheTEC-5002candetectwhethera5-inchor7-inchreelcuttingunitisinstalled.Allcuttingunitsizesmust
matchincuttingunits1through5beforethemachinefunctionsnormally.
ConditionsforSettingtheFault
TheTEC-5002detectsthatallofthecuttingunitsarenotthesamereeldiameter.
RecommendedServiceActions
Step1:Verifythatthefaultrepeats.
1.ClearthesystemfaultsfromtheInfoCenter.RefertoClearingFaultsfromtheInfoCenter(page21).
2.Operatethemachine.
Pass
Thefaultdidnotrepeat.GotoReturningtheMachinetoService(page22)andfollowthestepslisted.
Note:Ifthefaultdoesnotrepeat,anisolatedeventhasoccurred.
Fail
Thefaultrepeated.GotoStep2.
Step2:Verifythatall5cuttingunitshavethesamediameterreel.
1.Visuallyinspectall5cuttingunitsandverifythatthemachineisequippedwithcuttingunitsthatarethe
samesize(either5-inchor7-inchdiameter).RefertoFigure121forthelocationsofthecuttingunits.
206