5.RFID ANALYZE TOOL EO13-33002
(Revision Date: Jul. 24, 2008)
5.4 Operatin Procedure
5- 15
4. When the “CommSetting” screen appears, perform the serial port or LAN setting in accordance with the
settings of the B-SX6T/SX8T printer.
NOTES:
1. Choose the port to which the printer is connected.
2. Choose “NON” for the Flow control of the RFID Analyze Tool. However, any flow control code of the
printer is acceptable.
3. The data bit for the Analyze Tool is fixed to 8. Make sure that the data length for the printer is set to 8
bits.
4. The command flame for the Analyze Tool is “{ | }”. Make sure that the control code for the printer is set
to “AUTO” or “{ | }”.
5. When the printer and the PC are connected via LAN, a printer IP address and socket port number need
to be entered.
Default Printer IP Address: 192.168.10.20, Socket Port No.: 8000
Port: COM1 to COM9
Baudrate: 2400, 4800, 9600, 19200, 38400, 115200
Data bit: 8 bit
Parity: NONE, EVEN, ODD
Stop bit: 1, 2
Flow control: NON, XON, XON/XOFF,
RTS/CTS+XON/XOFF
Printer IP Address
Socket Port No.
To Next Page
Loading...
