Toshiba B-SX6T Series - DHCP Host Name Setting

2. SYSTEM MODE EO13-33002
2.7 IP Address Setting
2-69
2.7.4 DHCP Host Name Setting
After DHPC client ID has been set, the DHCP host name setting menu is displayed.
Press the [PAUSE] key and set the DHCP host name one byte by one byte.
NOTES:
1. Code used to enter a DHCP client ID is selectable between ASCII code (alphanumeric) and Hex. code.
2. Set a character or value for each byte by using the [RESTART] or [FEED] key.
[RESTART] key: Increment [FEED] key: Decrement
3. Press the [PAUSE] key to enter the next byte. Repeat this until 16th byte is entered.
4. After the 16th byte of the DHCP host name is set, press the [PAUSE] key. At this time, the display will turn to
“<7>IP ADDRESS”.
5. A DHCP ID can be used to check what IP address is assigned to which client on a DHCP server. If a DHCP
ID is not assigned, MAC address of a network device (LAN card or LAN interface board) will be notified to the
server as a DHCP ID instead.
A DHCP ID is a 16-byte character string. As “FFH” (hex. code) is recognized as a terminator, if the top byte of
DHCP ID is “FFH”, it is considered that a DHCP ID is not assigned.
ASCII code and Hex. code correspondence table
Upper 4 bits
Lower 4 bits
2 3 4 5 6 7
0 SP 0 @ P ` P
1 ! 1 A Q a q
2 “ 2 B R b r
3 # 3 C S c s
4 $ 4 D T d t
5 % 5 E U e u
6 & 6 F V f v
7 ‘ 7 G W g w
8 ( 8 H X h x
9 ) 9 I Y i y
A * : J Z j z
B + ; K [ k {
C , < L \ l |
D - = M ] m }
E . > N ^ n
F / ? O _ o
SP = Space
When the system mode settings have been completed, turn off the printer.
MODE ASCII
DHCP HOST NAME
[PAUSE]
[PAUSE]
MODE ASCII

Enter a character or a value for each of 1st byte to 16th byte
sequentially using the [FEED] or [RESTART] key.
(Example) To enter “TOSHIBA” in Hex. code:
54 4F 53 48 49 42 41
<7>IP ADDRESS