2. SYSTEM MODE EO13-33002
2.3 Printer Parameter Fine Adjustment
2-37
2.3.1 Print Start Position Fine Adjustment
This parameter is to fine adjust a print start position after printing (= to fine adjust the feed amount to the
next media’s print start position).
When “<3>ADJUST SET” appears, press the [PAUSE] key.
Use the [FEED] or [RESTART] key to select a desired option. (Range: -50.0 mm to +50.0 mm)
[FEED] key: Pressing the [FEED] key one time causes a –0.1 mm change, up to –50.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1 mm change, up to +50.0 mm.
After completing the fine adjustment, press the [PAUSE] key.
• Print Start Position Fine Adjustment (Example)
NOTE: The fine adjustment value equals to the sum of the fine adjustment values set by the PC command and
this parameter.
The maximum print position fine adjustment value is +
50.0 mm. When the value reached the maximum,
the value remains unchanged even if the subsequent fine adjustment is performed.
<3>ADJUST SET
FEED ADJ. +0.0mm
[RESTART]
[FEED]
FEED ADJ.+50.0mm
FEED ADJ.+49.9mm
FEED ADJ.+0.0mm
FEED ADJ.-49.9mm
FEED ADJ.-50.0mm
FEED ADJ.+0.1mm
FEED ADJ.-0.1mm
To Next Page
Loading...
