2. SYSTEM MODE EO13-33002
2.3 Printer Parameter Fine Adjustment
2-36
How to Enter Printer Parameter Fine Adjustment Mode
Turn on the printer while pressing the [FEED] and [PAUSE] keys at the same time. Hold both keys until the
“<1>DIAG. Vx.x” Message appears.
Press the [FEED] key twice.
The printer is at the start of the Printer Parameter Fine Adjustment menu.
NOTES: 1. When pressing the [FEED] and [RESTART] keys at the same time in the parameter setting, the
message returns to “<3>ADJUST SET”.
2. If holding the [FEED] or [RESTART] key for 0.5 seconds or longer in the Printer Parameter Fine
Adjustment, the key is entered continuously.
3. A changed parameter becomes effective by pressing the [PAUSE].
4. Use the [FEED] or [RESTART] key to select a desired value or option.
<1>DIAG. Vx.x
<3>ADJUST SET
To Next Page
Loading...
