Toshiba B-SX6T Series - Self-Diagnostic Test

2. SYSTEM MODE EO13-33002
2.1 Self-diagnostic Test
2- 3
2.1 Self-diagnostic Test
 Outline of Self-diagnostic Test
In the Self-diagnostic test mode, the printer automatically checks and prints out the printer system
information such as the sensor status or interface, and the maintenance counter. Also it performs a print
head broken element check.
The Self-diagnostic test contains the following sub menus:
NOTE: Use the [FEED] or [RESTART] key to select a desired option.
 How to Enter Self-diagnostic Test Mode
Turn on the printer while pressing the [FEED] and [PAUSE] keys at the same time. Hold both keys until the
“<1>DIAG. Vx.x” message appears in the display.
[PAUSE]
[PAUSE]
[FEED]
[FEED]
[RESTART]
[RESTART]
[FEED]
Selection of the printing mode.
Prints out the Maintenance Counter /Parameter Settings.
Performs a Self-Diagnostic Test, and prints out the result.
Checks to see if there is any problem with the print head.
<1>DIAG. Vx.x
<1>DIAG. Vx.x
AUTO DIAGNOSTIC
<1>DIAG. Vx.x
MAINTENANCE CONT.
<1>DIAG. Vx.x
HEAD CHECK
<1>DIAG. Vx.x
PRT TYPE TRANSFR
[RESTART]
<1>DIAG. Vx.x
[PAUSE]
Selection of the dispensing mode.
<1>DIAG. Vx.x
TYPE[S] NO CUT
[PAUSE]
[PAUSE]
[PAUSE]