2. SYSTEM MODE EO13-33002
(Revision Date: Jul. 24, 2008)
2.9 RFID Module Setting
2-77
2.9.5 Maximum Number of RFID Issue Retries
This parameter is to set the maximum number of times to issue an RFID tag. If the printer fails to issue an
RFID tag, it prints an error pattern (“VOID”) and retries to issue the tag for up to a specified number of times.
If the printer does not succeed even after having retried for the maximum number of times, the printer stops,
resulting in an error (RFID WRITE ERROR).
When “ISSUE RETRY 3” is displayed, press the [PAUSE] key.
Use the [FEED] or [RESTART] key to select a desired option. (Range: 0 to 255)
[FEED] key: Pressing the [FEED] key one time causes a –1 change, up to 0.
[RESTART] key: Pressing the [RESTART] key one time causes a +1 change, up to 255.
After selecting the maximum number of issue retries, press the [PAUSE] key.
<10>RFID
ISSUE RETRY 3
[RESTART]
[FEED]
ISSUE RETRY 255
ISSUE RETRY 3
ISSUE RETRY 2
ISSUE RETRY 1
ISSUE RETRY 0
To Next Page
Loading...
Need help?
General