Toshiba B-SX6T Series - Printer Accessories

2. SYSTEM MODE EO13-33002
2.1 Self-diagnostic Test
2- 5
2.1.3 Maintenance Counter/Parameter Settings Print Out
When “MAINTENANCE CONT” is displayed, the printer is ready to print out the Maintenance
Counter/Parameter Settings. Press the [PAUSE] key to start.
• Print Sample
<1>DIAG. Vx.x
MAINTENANCE CONT
<1>DIAG. Vx.x
CHECKING & PRINT
TOTAL FEED 1.1km [QM]
FEED 1.1km
PRINT 0.5km
CUT 96
HEAD U/D 12320
RIBBON 3h
SOLENOID 2h
232C ERR 255
SYSTEM ERR 0
POWER FAIL 0
[PC] [KEY]
FEED +2.0mm FEED +0.0mm
CUT +0.0mm CUT +1.0mm
BACK +0.0mm BACK +0.0mm
TONE(T) +0 step TONE(T) +0 step
TONE (D) +0 step TONE(D) +0 step
RBN(FW) -10 RBN (FW) -8
RBN (BK) +0 RBN (BK) +0
X ADJ. +0.0mm
THRESHOLD (R) 1.0V
THRESHOLD (T) 1.4V
FONT [PC-850] [0]
SPEED [9600]
DATA LENG. [8]
STOP BIT [1]
PARITY [EVEN]
CONTROL [XON+READY AUTO]
MESSAGE [ENGLISH]
FORWARD WAIT [ON] +0.0mm
HEAD UP CUT [ON]
RIBBON SAVE [ON:LABEL]
CODE [AUTO]
RIBBON [TRANS]
PEEL OFF STATUS [ON]
FEED KEY [FEED]
KANJI [TYPE1]
EURO CODE [B0]
A
UTO HD CHK [OFF]
A
CK/BUSY [TYPE1]
WEB PRINTER [OFF]
SENSOR POSITION [CENTER]
INPUT PRIME [ON]
EX. I/O MODE [TYPE1]
PLUG & PLAY [OFF]
LBL/RBN END [TYPE1]
PRE PEEL OFF [ON] +0.0mm
BACK SPEED [STD]
MAXI CODE SPEC. [TYPE1]
PEEL OFF TRQ [R3]
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
(22)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
(37)
(38)
(39)
(40)
(41)
(42)
(43)
(44)
(45)
(46)
(47)
(48)
------------------------------------------------------------------------------
<1>DIAG. Vx.x
[PAUSE]