2. SYSTEM MODE EO13-33002
(Revision Date: Jul. 24, 2008)
2.9 RFID Module Setting
2-78
2.9.6 Maximum Number of RFID Read Retries
This parameter is to set the maximum number of times to read an RFID tag.
If the printer does not succeed even if after having retried for the maximum number of times, the printer
stops, resulting in an error (TIMEOUT). In case of frequent read errors, increase this retry count. However,
when the retry count is increased, a data read may become slower.
If the specified time-out runs out, the printer stops retry even before the maximum number of retry times is
reached. The printer always reads an RFID tag for a maximum number of retry times set by this parameter
before writing data to the RFID.
When “R CYCLE CNT 5” is displayed, press the [PAUSE] key.
Use the [FEED] or [RESTART] key to select a desired option. (Range: 0 to 255)
[FEED] key: Pressing the [FEED] key one time causes a –1 change, up to 0.
[RESTART] key: Pressing the [RESTART] key one time causes a +1 change, up to 255.
After selecting the maximum number of read retries, press the [PAUSE] key.
<10>RFID
R CYCLE CNT 5
[RESTART]
[FEED]
R CYCLE CNT 255
R CYCLE CNT 3
R CYCLE CNT 2
R CYCLE CNT 1
R CYCLE CNT 0
To Next Page
Loading...
