Toshiba B-SX6T Series - RAM Clear

2. SYSTEM MODE EO13-33002
(Revision Date: May 22, 2007)
2.6 RAM Clear
2-61
2.6 RAM Clear
 Outline of RAM Clear
In the RAM Clear mode, clearing the Maintenance Counter and initializing the Parameters are possible.
After replacing the print head, ribbon motor, or platen, perform a maintenance clear.
The RAM Clear menu contains the following:
 How to Enter RAM Clear Mode
Turn on the printer while pressing the [FEED] and [PAUSE] keys at the same time. Hold both keys until the
“<1>DIAG. Vx.x” Message appears.
Press the [FEED] key 5 times. The printer is at the start of the RAM Clear menu.
<1>DIAG. Vx.x
<6>RAM CLEAR
<6>RAM CLEAR
NO RAM CLEAR
<6>RAM CLEAR
MAINTE.CNT CLEAR
<6>RAM CLEAR
PARAMETER CLEAR
<6>RAM CLEAR
No RAM Clear
[PAUSE]
[FEED]
[FEED]
[FEED]
Maintenance Counter Clear
Parameter Clear
[RESTART]
[RESTART]
[RESTART]
ALL CLEAR
[FEED]
[RESTART]
FEED&PRINT CLEAR
[FEED]
[RESTART]
CUT CLEAR
*** COMPLETE ***
[PAUSE]
[PAUSE]
[PAUSE]
[PAUSE]
B-SX6T and
B-SX8T (V1.0B or earlier)
B-SX8T (V1.1 or greater)
Turn off the printer to exit this mode.
[PAUSE]