Toshiba B-SX6T Series - Specifying the Print Condition for the Test Print

2. SYSTEM MODE EO13-33002
2.4 Test Print
2-49
2.4.1 Specifying the Print Condition for the Test Print
The print conditions for the Test Print should be specified before printing.
When “<4>TEST PRINT” appears, press the [PAUSE] key.
To set the print conditions, press the [PAUSE] key.
Issue Count Setting
Select an issue count from a range of 1 to 5000.
After selecting an issue count, press the [PAUSE] key to go to Print Speed Setting.
Print Speed Setting
Select a print speed for the test print among 8”/sec., 4”/sec., and 3”/sec.
After selecting a print speed, press the [PAUSE] key to go to Sensor Type Selection.
<4>TEST PRINT
PRINT CONDITION
[RESTART]
[FEED]
ISSUE COUNT 5000
ISSUE COUNT 1000
ISSUE COUNT 500
ISSUE COUNT 100
ISSUE COUNT 50
ISSUE COUNT 10
ISSUE COUNT 5
ISSUE COUNT 3
ISSUE COUNT 1
<4>TEST PRINT
ISSUE COUNT 1
<4>TEST PRINT
PRINT SPEED 4”/s
[RESTART]
[FEED]
PRINT SPEED 4”/s
PRINT SPEED 3”/s
PRINT SPEED 8”/s