Toshiba B-SX6T Series - Plug & Play Selection; Label End;Ribbon End Selection

2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-31
2.2.24 Plug & Play Selection
This parameter is to choose whether to enable a Plug & Play function.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTE: If the printer and the PC are connected by USB, plug & play will be automatically enabled, regardless of
the setting of this parameter.
After selecting a Plug & Play, press the [PAUSE] key.
2.2.25 Label End/Ribbon End Selection
This parameter is to choose a printing process when a label end or ribbon end is detected. For details, refer
to NOTE on the following page.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Label End/Ribbon End type, press the [PAUSE] key.
<2>PARAMETER SET
PLUG & PLAY OFF
PLUG & PLAY OFF
PLUG & PLAY ON
[RESTART]
[FEED]
Unavailable
Available
<2>PARAMETER SET
LBL/RBN END TYP1
LBL/RBN END TYP1
LBL/RBN END TYP2
[RESTART]
[FEED]
TYPE1: When a label/ribbon end is detected in the middle
of printing, printing is immediately paused.
TYPE2: When a label/ribbon end is detected in the middle
of printing, the printer prints the half-finished label as far as
possible, and stops when the next label is at the home
position.