2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-29
2.2.20 Web Printer Function Selection
This parameter is to choose whether to use the printer as a web printer.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Web printer function, press the [PAUSE] key.
NOTE: When “WEB PRINTER ON” is selected, the status of the printer connected in a network can be checked
through the Web browser.
2.2.21 Media Sensor Selection
This parameter is to choose the media sensor type to be used.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the media sensor type, press the [PAUSE] key.
<2>PARAMETER SET
WEB PRINTER OFF
WEB PRINTER OFF
WEB PRINTER ON
[RESTART]
[FEED]
Unavailable
Available
<2>PARAMETER SET
SENS POSI CENTER
SENS POSI CENTER
SENS POSI EDGE
[RESTART]
[FEED]
Fixed sensor
Movable sensor
To Next Page
Loading...
Need help?
General