Toshiba B-SX6T Series - Operating Environment Configuration

2. SYSTEM MODE EO13-33002
2.2 Parameter Setting
2-27
2.2.15 FEED Key Function Selection
This parameter is to choose the function of the [FEED] key.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the FEED key function, press the [PAUSE] key.
2.2.16 KANJI Code Selection
This parameter is to choose a KANJI code.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTE: Kanji code selection is not supported by the QM model as the Kanji ROMs are not installed.
After selecting a Kanji code, press the [PAUSE] key.
2.2.17 EURO Code Selection
This parameter is to choose a Euro code (€).
When “<2>PARAMETER SET” appears, press the [PAUSE] key until the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
NOTE: Pressing the [FEED] or [RESTART] key causes 1 byte change in the Euro Code value.
After selecting a Euro code, press the [PAUSE] key.
[RESTART]
[FEED]
<2>PARAMETER SET
EURO CODE B0
EURO CODE 20
EURO CODE 21
EURO CODE FE
EURO CODE FF
<2>PARAMETER SET
KANJI CODE TYPE1
KANJI CODE TYPE1
KANJI CODE TYPE2
[RESTART]
[FEED]
Windows code
Original code
<2>PARAMETER SET
FEED KEY FEED
FEED KEY FEED
FEED KEY PRINT
[RESTART]
[FEED]
The [FEED] key will feed one media when pressed.
The [FEED] key will print the data in the Image Buffer
(The last printed data)