Toshiba e-STUDIO556 - Page 179

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 33
[ 2 ] Drawer empty sensor (S31/S37/ S43/ S49)
[ 3 ] Tray-up sensor (S32/S38/S44/S50)
(3) Remove 1 clip to take off the feed roller.
(4) Remove 1 clip to take off the separation
roller.
Fig. 4-92
(1) Disconnect 1 connector to take off the
drawer empty sensor.
Fig. 4-93
(1) Disconnect 1 connector.
(2) Pull the lever and take off the tray-up sensor
while the pickup roller is lowered.
Fig. 4-94
Feed roller
Separation roller
Drawer empty sensor
Tray-up sensor