4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 53
[ 6 ] Tandem LCF tray-up motor (M41)
(2) Disconnect the connector for each sensor,
and take off the sensor.
Fig. 4-150
(1) Take off the switching regulator.
( P.9-6 "9.1.8 Switching regulator (PS)")
(2) Disconnect 1 connector, remove 3 screws
and take off the Tandem LCF tray-up motor.
Fig. 4-151
End fence
home position sensor
Standby side empty sensor
End fence
stop position sensor
Tandem LCF tray-up motor Screw
Screw
To Next Page
Loading...
